Sun Inverter

The Victron Sun Inverter combines a sinewave inverter and a PWM solar charger in one enclosure and is easy to install, with a minimum of wiring.

The solar charger ensures that the batteries are being charged by energy harvested from your solar panels. The charge algorithm is programmable.

The inverter and solar charger parameters can be read out via Bluetooth using the VictronConnect app. In addition to this, the Victron Sun Inverter has a VE.Direct Port for connection to a GX device or GlobalLink 520 for system monitoring.

The VE.Direct Port can be used for connection to a GX device or GlobalLink 520 for system monitoring.

Monitoring via the VictronConnect app or GX device:

Inverter in- and output voltage and % load. Solar power, voltage, and current. Operational state and alarms

The Victron Sun Inverter allows you to power domestic equipment – requiring 230V AC – using ‘leisure’ or ‘automotive’ batteries rated at 12V or 24V.

Fully configurable via the VictronConnect app:

Low battery voltage alarm trip and reset levels

Low battery voltage cut-off and restart levels

Dynamic cut-off: load dependent cut-off level

No special cable terminals or tools are needed for installation of the Victron Sun Inverter

Output voltage 210 – 245V and Frequency 50 Hz or 60 Hz

ECO mode on/off and ECO mode sense level

Battery charge current, algorithm, and voltages

Battery charge temperature compensation or low temperature cut of level

ECO mode

When in ECO mode, the Victron Sun Inverter will switch to standby when the load decreases below a pre-set value (min load: 15W). Once in standby, the inverter will switch on for a short period (adjustable, default: every 2,5 seconds). If the load exceeds a pre-set level, the inverter will remain on.